GSM SIM 900A Wont send a Message Using Arduino UNO - arduino

Question

My Connections are
5VT to D9
5VR to D10
And external adaptor for power.. (5v 2A)
The blinks are good because it blinks every 3seconds,
The sim card is loaded.
But when I run the serial monitor, It only shows AT AT AT sometimes AT with reverse question marks..
Here is the Code I am using..
#include <SoftwareSerial.h>
SoftwareSerial mySerial(9, 10);
void setup()
{
mySerial.begin(9600); // Setting the baud rate of GSM Module
Serial.begin(9600); // Setting the baud rate of Serial Monitor (Arduino)
delay(100);
}
void loop()
{
if (Serial.available()>0)
switch(Serial.read())
{
case 's':
SendMessage();
break;
case 'r':
RecieveMessage();
break;
}
if (mySerial.available()>0)
Serial.write(mySerial.read());
}
void SendMessage()
{
mySerial.println("AT+CMGF=1"); //Sets the GSM Module in Text Mode
delay(1000); // Delay of 1000 milli seconds or 1 second
mySerial.println("AT+CMGS=\"[phone]\"\r"); // Replace x with mobile number
delay(1000);
mySerial.println("I am SMS from GSM Module");// The SMS text you want to send
delay(100);
mySerial.println((char)26);// ASCII code of CTRL+Z
delay(1000);
}
void RecieveMessage()
{
mySerial.println("AT+CNMI=2,2,0,0,0"); // AT Command to receive a live SMS
delay(1000);
}
This is the Sim900A I am using together with Arduino Uno..

Answer 1

Check out this code for simple data sending using GSM.
#include <SoftwareSerial.h>
SoftwareSerial ph(9,10); // RX, TX of gsm
void setup() {
Serial.begin(9600);
ph.begin(9600);
sms(600);
}
void loop() {
// put your main code here, to run repeatedly:
}
void sms(float amount) {
ph.println("AT+CMGF=1");
delay(1000);
ph.println("AT+CMGS=\"123456789\"\r"); //Enter your number in place of 123456789
delay(1000);
ph.print("Amount: ");
ph.println(amount);
delay(100);
ph.println((char)26);// ASCII code of CTRL+Z
delay(1000);
}